Cut plan CP-26-0405

Yield

99.8%

of the metal used up

First-pass use

90.4%

before anything went back

Scrap

0.21kg

$2 of metal

Off the rack

0.00m

$0 not bought new

Back on the rack

3.96m returned

How it nested

Each length that was opened, what came out of it, and what was left.

Cut 3300mm · 5mm kerf · 30mm end trim on a new bar

Mill length 7300mm mill length 7,300mm 2 × 3,300mm 660mm → New remnant RMN-0166

3300

660mm

Mill length 7300mm mill length 7,300mm 2 × 3,300mm 660mm → New remnant RMN-0167

3300

660mm

Mill length 7300mm mill length 7,300mm 2 × 3,300mm 660mm → New remnant RMN-0168

3300

660mm

Mill length 7300mm mill length 7,300mm 2 × 3,300mm 660mm → New remnant RMN-0169

3300

660mm

Mill length 7300mm mill length 7,300mm 2 × 3,300mm 660mm → New remnant RMN-0170

3300

660mm

Mill length 7300mm mill length 7,300mm 2 × 3,300mm 660mm → New remnant RMN-0171

3300

660mm

into the ramp saw kerf back on the rack scrap end trim

The cut list

What the saw operator works from.

#	Take from	Its length	Cuts	At	Left	Then
1	Mill length 7300mm mill length	7,300mm	2	3,300mm	660mm	New remnant RMN-0166
2	Mill length 7300mm mill length	7,300mm	2	3,300mm	660mm	New remnant RMN-0167
3	Mill length 7300mm mill length	7,300mm	2	3,300mm	660mm	New remnant RMN-0168
4	Mill length 7300mm mill length	7,300mm	2	3,300mm	660mm	New remnant RMN-0169
5	Mill length 7300mm mill length	7,300mm	2	3,300mm	660mm	New remnant RMN-0170
6	Mill length 7300mm mill length	7,300mm	2	3,300mm	660mm	New remnant RMN-0171
Total			12	39.60m	4.02m